Nd-Fe-B MELT - SPUN POWDER QUALITY ESTIMATION BASED ON STONER - WOHLFARTH MODEL
Author affiliations
DOI:
https://doi.org/10.15625/0868-3166/V14No1.17Abstract
The squareness factor, defined as the ratio BH c / i H c , plays very importance role. This factor reflects the magnetization process under a reversed magnetic field in magnet. So the factor can be used as the critical parameter for estimating the magnet quality. For the powder compaction of 6.48 g/cm 3 mass density, if is less than 0.48 then the preparation conditions were far from the optimal ones. The value higher than 0.48 of factor proves that in prepared powder the coupling between grains is enhanced. From the theory and the experiments it was proved that for full dense compaction of NdFeB Stoner-Wohlfarth particles the squareness factor and the maximum energy product(BH)max can not be lager than 0.53 and 10.7 MG. Oe, respectively.Downloads
Downloads
Published
How to Cite
Issue
Section
License
Communications in Physics is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Copyright on any research article published in Communications in Physics is retained by the respective author(s), without restrictions. Authors grant VAST Journals System (VJS) a license to publish the article and identify itself as the original publisher. Upon author(s) by giving permission to Communications in Physics either via Communications in Physics portal or other channel to publish their research work in Communications in Physics agrees to all the terms and conditions of https://creativecommons.org/licenses/by-sa/4.0/ License and terms & condition set by VJS.


