Influence of ASE Noise on Performance of DWDM Networks Using Low-power Pumped Raman Amplifiers
Author affiliations
DOI:
https://doi.org/10.15625/0868-3166/25/2/6000Keywords:
dense-wavelength-division-multiplexing (DWDM), distributed raman amplifier (DRA), amplified spontaneous emission (ASE)Abstract
We present the results of investigation for influence of amplified spontaneous emission (ASE) noise, noise figure (NF) and chromatic dispersion on the performance of middle-distance Dense-wavelength-division-multiplexing (DWDM) networks using low-power pumped distributed Raman amplifiers (DRAs) in two different pump configurations, i.e., forward and backward pumping. We found that the pumping configurations, ASE noise, and dispersion play an important role for improving network performance by decrease of noise figure and bit error rate (BER) of the system. Simulation results show that the lowest bit error rate and low noise figure were obtained, when using forward pumping configuration. Moreover, we have also compared ASE noise powers of the simulation with these of the experiment. These results conclude that DRA with low pump power ($<1$~W) is the promising key technology for short-- and/or middle-distance DWDM transmission networks.Downloads
Downloads
Published
How to Cite
Issue
Section
License
Communications in Physics is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Copyright on any research article published in Communications in Physics is retained by the respective author(s), without restrictions. Authors grant VAST Journals System (VJS) a license to publish the article and identify itself as the original publisher. Upon author(s) by giving permission to Communications in Physics either via Communications in Physics portal or other channel to publish their research work in Communications in Physics agrees to all the terms and conditions of https://creativecommons.org/licenses/by-sa/4.0/ License and terms & condition set by VJS.


